Router Table for rounding over all edges

1/4" blade bandsaw for tight turns round handle

Lots of power sand a must

Table Saw used to put a saw kerf down the middle edge of the 2x6

chopsaws used to cut the 2x6x8 into 2x6x2

Vgroove router bit to cut the top barrell grove out.

1" spade bit to cut out the finger hole drill from both sides to avoid split out.

Stack of 37 guns

side profile with chapstick for a size comparison rubberband is a 7" x 1/8" box of 200 from staples

Bandsaw motor went belly up

226.00 for a new motor and you can buy a new badsaw for less. hum.